- This topic has 32 replies, 5 voices, and was last updated 6 years, 11 months ago by
.
-
Posts
-
Hello and good day. Unfortunately today I had a bad surprise because I followed the instructions you gave me ,so this week I interposed between the Domopak pitch and mirror but unfortunately this morning I found the surprise… In fact they are glued. I simply can not detach!
I'm trying to find a way to avoid ruining you recommended tutto..Cosa?hello Luigi, sometimes happens… solution: Immersion in warm water, They should disconnect almost immediately !
And, the ambient temperature with pitch, and in the long resting period may cause some surprises. There are those who leave the tool on the film with the garnished pitch of a brushstroke of cerium oxide, but it is not a good rule.
The best adaptation occurs only when it is done just before the start of work, then at an ambient temperature can allow that in those few minutes of manual pressure. But this, It is not a mandatory behavior, if not in phase parabolizzazione.
- You must be logged in to reply to this topic.